Foundation Prep

  • Before installing the turf, it is important that the ground on which the turf will be laid is smooth and firm.
  • Remove any bumps, roots, rocks, sticks or any other debris to ensure a flat surface and pack down to make it firm.
  • If the turf is going to border a patio or some sort of concrete slab, make sure that the surface is 5 inches below the top of the patio or driveway-like surface, because you will need to account for 4 inches of the crushed rock base.

Crushed Rock Base

  • There should be a layer of finely crushed stone (where the rocks are 1⁄4″ size) between the dirt surface and the new turf. This serves as a drainable base.
  • Depending on where you live, this may have different names. The most common are: 1⁄4″ minus compaction aggregate, road base, chat or decomposed granite.
  • When buying the finely crushed stone, you will want to get approximately two tons of this crushed rock per 100 square feet, which should equate to a 4-inch-thick layer, leaving 1 inch below the top of the patio/driveway.
  • Obviously, you want to spread this as evenly as possible (with a rake), compact it (with vibratory plate compactor or other device to about 90 – 95%), lightly soak it with water and then pass over it again. Once this is done, add the finishing layer of finely crushed stone and pack it down.

Turf Preparation and Installation

Before cutting the turf to fit the area, start by simply laying the piece or pieces of turf over the area. There are two important considerations when laying two or more separate pieces or rolls of turf in the same area.Grain should go in same direction. Make sure the grain is running in the same direction, before cutting. When cutting the turf for straight edges, use the tufted rows (the lines on the backing) as guides for ensuring a straight cut. Also, make sure that these tufted rows are aligned, going the same direction.

Artificial Grass Install Tips

Ensure Good Seams. To stabilize two pieces of turf together, we recommend using “seaming tape” with adhesive applied to it.

  1. Once the pieces of turf are cut to the desired shapes and sizes, place them over
    the area with the tuft rows matched up properly.
  2. Hammer a nail within a foot or so of the edge of the turf where the seam will be to
    stabilize it.
  3. Roll back the edges of the turf which will eventually be joined together.
  4. Place some sort of weight on the folded back pieces to hold them down while laying the seaming fabric.
  5. Lay cloth and pour on adhesive. Follow included adhesive instructions.
  6. Lay edges of turf back over adhesive. Add weight and let dry.

Securing the Turf

Secure your turf by using 6” spikes around the seams (every four inches), around the edges (every foot) and sporadically throughout the middle.

Installing the Infill

Infill can be sand, rubber pellets or a combination of both. Its purpose is to support the fibers and provide bulk to the turf to weigh it down.

  1. Brush the fibers so they are standing as straight up as possible.
  2. Spread infill evenly over turf with a drop spreader like you would use to spread
    fertilizer.
  3. Read the description of your turf to find the amount of infill needed.
  4. In between spreading layers of infill, use a broom to brush it into the fibers.
  5. The infill should total 3⁄4 of the height of the blade, leaving 1⁄4 inch of fiber
    exposed above the infill.

Long-Term Maintenance

A leaf-blower can be used to clear debris and dust. Every few months, you will want to sweep or brush the turf so that the fibers continue to stand up. Power Brooms may save considerable time on larger areas of turf.